Posted by Waterloo on November 12, 2007 at 19:51:34 from (74.171.133.160):
In Reply to: O/T Ballistic Bullets posted by Dalton S. on November 12, 2007 at 18:31:28:
I have reloaded rifle and handgun bullets for many years. The replies made in response to your question are correct. I do not believe the bullets will fit in your gun, do to the larger size of the cases. However, if the bullets fit "DO NOT FIRE THESE BULLETS IN YOUR GUN". The pressure from these bullets will most likely damage your gun or kill you. The bullets you purchased are for a gun designed to work at much higher pressures than your gun was built to handle. The ballistic tip bullets were originally designed by Nosler. There have been several copies of these bullets over the years due to the success these bullets develop on deer size game. I have personally taken and reloaded for people who have shot deer with these bullets. The success rate for a ballistic tip design bullet is very high. Most of my deer hunting reloads have been for a .308 size bullet. A 270 Win. is a good round offering a fairly flat shooting design. Make sure the bullets you buy for your "guns" match the info on the barrel of your gun.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
