I haven't actually tried it, but I had the same idea on my D19. What I thought of doing was to put a valve on a splitter, couple the valve to one of the two way valves on the tractor, and then tie the lever down on the tractor to provide a constant flow of fluid through the valve on the splitter.
The lift arms on the D series are one way, but I believe they also have at least one two way hook-up to the rear. My D19 has two two way valves on to the rear and a one way valve that can select between the lift arms and a single acting remote cylinder.
I did the same thing with a VAC Case once, but as I recall I ran a separate pump off the PTO instead of using the tractor's pump.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.