Posted by n8terry on November 23, 2007 at 18:55:50 from (172.194.179.215):
I am doing a conversion from 6 to 12 volt generator. The new regulator has got me puzzled. It has 4 terminals on it where the 6 volt one has the typical 3 terminals, Batt, Arm, Field.
The new regulator has Batt, Arm, Field, and a terminal marked with an L. The instructions go into detail about installation and how to Polarize. These instructions don't say a word about what to connect to the L terminal. There are times that I would like to choke the person that writes instructions, and this is one of them!
Any of you guys have any ideas what the L terminal should be used for?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
