Hi Old , I'm not a revolver person but do you use speedy loaders or do you have to press each ball into cylinder on the gun ? Either way what you're doing is what I've seen done . Make sure the cap fit's tight otherwise that may be where you're picking up the spark . Is the cylinder indexed correctly and slop free ? A little mismatch there will throw a thin sliver of lead back into the next hole going through a thin layer of grease exposing it to a spark . You'll get that anyway but if everything is lined up well it shouldn't be that bad . Others here probably have more experience on this than I do . Good luck ! ...Randy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.