Posted by 135 Fan on November 29, 2007 at 10:25:34 from (68.149.38.173):
In Reply to: Got A Minute? posted by Allan In NE on November 29, 2007 at 08:17:56:
I wonder if a rental outfit would have a portable A-frame hoist. I've seen them before. Lifting it up and having to move it around to get it in position, I'd be really worried about the loader creeping down or worse, a hydraulic failure. I used an engine hoist and my skid steer to move it, to pull and replace the engine and tranny in my Cat. The engine hoist gave me precise adjustments which made it a lot easier. Being that you have a lot more ackward placement to get it into, it would be good to use a real safe method to do it. I wonder if you could hire a service truck from a heavy equipment repair outfit with the crane on the side? Might cost a couple hundred bucks but would make your job a lot easier. Good luck. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
