Posted by D-C-741 on December 02, 2007 at 13:40:14 from (24.59.108.153):
In Reply to: Re: Get Me The Gun! posted by Allan In NE on December 02, 2007 at 12:18:19:
We had the same problem with our old Oliver 70 and 830 Case, we had valve jobs done at a local shop and the guy Screwed up on all 3 heads, when he did the SEATS ,he didn't use or get the Stem streight,and didn't do the seats right,we took apart found the Guides were junk, had to have them done all over again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.