|
Tractor Talk Discussion Board |
Re: Re: Re: Confused on coil
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by J Hagen on December 07, 1999 at 19:51:03 from (206.29.96.46):
In Reply to: Re: Re: Confused on coil posted by MikeH(Tx) oops on December 07, 1999 at 18:56:22:
Guys all this got me so worked up that I dug out my old automotive mechanics book and looked up ignition coils. The average secondary voltage built is 20,000 volts . 20,000 divided by 12V = 1666 to 1 winding ratio,3333 to 1 for 6V. With 20,000 volts grounding itself through the few ohms of primary winding ,the effect is that the secondary winding is grounded equally to both primary terminals. Real world experience has shown me that an engine with coil and battery wired with the same ground will fire better than when coil and battery polarity are oposite .
Also I perfer the 6V coil with a resistor over a 12V coil, as this gives you the option of by passing the resistor during cranking to give a much hotter spark for starting.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
