Posted by super99 on December 17, 2007 at 14:17:35 from (75.107.167.209):
Last saturday I went back to auto parts/ machine shop to talk to them about bringing block in to get checked before I ordered pistons, and told shop man that I had checked at the counter and they said they couldn't get pistons, so I'd have to get them somewhere else. He said to go back out and talk to Tony and have him check, so I did. He said to check back Monday, couldn't find anything on Sat. Stopped in tonite after work and checked with Tony. He can get pistons, rings, and pins and keepers for $185/ hole. Gasket set for $70. Can't get bearings or bushings for wrist pins if needed. That's cheaper than I had found anywhere else, so I told them as soon as I get the block out, I'll bring it in and let them have at it. Guess it pays to check back with the older guys that know what they are doing. Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.