Posted by doug in illinois on December 19, 2007 at 16:11:33 from (207.144.221.132):
In Reply to: How big of a disc posted by Dalton S. on December 19, 2007 at 11:17:54:
Used to pull a 12 ft Kewanee tandem disk behind a Ford 861 Powermaster. Was actually my mom's uncle, but we were his only relatives and actually lived on the same farm. Handled it fine, he had two chunks of railroad rail on the front hitch to keep the nose down and fluid in the tires. He used the same tractor on a 4 row 38 inch mounted lister. My opinion is, power not likely to be as big an issue as traction is. Just a guess, but think 10 ft would work well, if you can't find a true 10 ft, would suggest a 12 ft and just either remove the outer blade if there are enough threads on the shank to do that or just torch off most of the outer blade. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
