Posted by Bill46 on January 09, 2008 at 10:14:38 from (65.200.157.177):
In Reply to: IH 340 utility PTO posted by Mark W. on January 09, 2008 at 08:30:09:
I have pulled a mess of them...better if you have the manual...but it's pretty straight forward. Don't know about a 340...but if there is a seasonal disconnect unter the tractor...make sure it's engaged. Back it up on blocks to try and keep as much fluid in the case as possible. Unhook the linkage and remove the 4 bolts and pull it out. Going back...put a light coat of hyd oil on the o-rings so they slide in better. Be careful not to pinch them as they go in. You may have to turn the shaft a little to line up the shaft inside. Bolt it up and lower the tractor to level ground. Check the case oil...fill it as necessay and go for it. One note...make sue no dirt or water gets in that case while it's open.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
