Posted by ChrisB on January 12, 2008 at 15:42:32 from (71.88.106.1):
In Reply to: geo-thermal heating posted by TVB on January 12, 2008 at 07:34:13:
Here in the cooler part of New England, my heating bill will be $0 per month or $0 per winter or $0 for the year (I like easy math) for 2400sqft. Well insulated and heated all with wood.
Sure I pay for the equipment and fuel to process the wood but I equate this cost to a gym membership.
Plus (if you read the latest university studies) I am doing the world good by selecting wood and not oil. In short not pulling something up from underground to burn that has no right being above ground, versus a dead tree would emit the same gases when dead plus new growth forest is better for a green earth.
Been heating with wood all my adult life and the one thing I witnessed in Europe and is key to any heating is the air that is burned. Applies to any type of combustible heat source in a house and is similar to why we all consider a regular fireplace so inefficient.
If your heat source (no matter what it might be) uses air inside the structure to burn , not only is it burning air that you already heated even more damaging it is creating a negative pressure in the house. This pressure will of course try to even itself out by sucking in outside cold air.
I have seen studies where 10% to 14% of savings where realized just by drawing in outside air to burn.
Unfortunately the trend has not caught on in the US as much, but I see it from time to time. My wood stove comes from Norway and I would not trade it for the world. It has duct work much like a dryer to suck air from the outside, thus the combustion gases and all are completely isolated from the inside air. Same with the oil heater here (if needed).
While I do not keep the house hot and the temp inside swings a lot, I will use about 5 cord a wood this year and half of that will be pine ( please no preaching about burning pine).....
I did look into Geo-thermal to compliment the wood. But like electric cars all I see is switching from one evil that you have no control over (oil or gas) to another evil that you have no control over (electricity).
Much like another poster mentioned they went back to 50 year old technology and switched to coal and saved significantly. I would much rather go back 100 years and save it all. Plus I stay warm when the lights are out. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.