Posted by johnand cindy on January 15, 2008 at 09:46:27 from (66.240.12.100):
In Reply to: shop compressor posted by Jim Will on January 14, 2008 at 21:03:49:
install a dedicated 20AMP circuit. Inrush current too great check existing circuit with an amprobe. A 20 AMP is designed for 20A inrush current and operate at 16 AMPS 80% of total load.Also make sure wire size is correct #12. Also the receptical is 20A rated DO NOT buy junk outlets big brand names Hubbel,P&S,Woodhead, indrustrial grades are best. Do some research before making changes if unsure call a electrician. Been doing this for 33 years. John
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
