Posted by spencer13cat on January 26, 2008 at 20:12:54 from (71.149.143.236):
RodInNS said: (quoted from post at 12:38:22 11/23/07) I generally use two swivels unless the hose is very short or very easy to install. There are situations where two swivels are required as well...
I avoid JIC fittings if at all possible. Those have got to be the KING of leakers. I can't say that I've ever had a problem with pipe fittings leaking if the were installed properly. The JIC will leak and leak... and you keep tightening them, they still leak until you tighten them enough to strip the threads. Then you start over with a new adapter and another hose... I get rid of those things every chance I get.
Rod
Pipe thread fittings are the worst type of hydraulic connection period. I am a factory rep for Parker and have also sold Aeroquip in the past. I have close to 20 years in the industry. I am also Fluid Power Certified by the International Fluid Power Society.
I can understand your frustration with 37 degree JIC. But it is likely due to not completely understanding it. The most common cause of leaks with JIC is the cone on the male is scratched. Once that happens it is worthless. Any of the major manufacturers should have an assembly method for all types of fittings in their catalogs. JIC is flats from finger tight.
The best way to handle the original problem is to get a hose with a female JIC fitting and an adaptor with male NPT x male JIC. It is also much cheaper than the pipe swivel hose fitting by itself(Parker 113xx or Aeroquip 1PSxx. By the way the pipe swivel fitting is notorious for not being a long-term fix. the sealing mechanism is an o-ring inside the crimped male fitting.
O-ring face seal is better yet. It is almost idiot proof.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.