Posted by Roy in georgia on January 27, 2008 at 08:33:28 from (75.89.32.20):
In Reply to: Day 3 posted by Lanse on January 26, 2008 at 18:21:09:
Lance, from the primer on the tire and bottom of the steering wheel you are getting a bit hurried unless you plan on replacing them but that is still primer that would have been better served on the metal parts also the kero. might be marvel mystery oil unless the seller told you it was kero. some swear by marvel but I think PB would do the job fastest as that is the kind of thing it is supposed to do. old likes ATF and it may be great for this but he is more experienced and prob. more patient than some that want to try out the engine. slow down just a bit more spend a little time rubbing on it to prep those seams on the fenders while laying on the rear tires each way to keep it under some persuasion as you work. Spending more time in the small cracks and crevasses will make the overall appearance more appealing. I used to work at a body shop and now I can't stand to see where someone just painted instead of taking a few extra min. to prep the entire job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
