You coulda made smaller nests, 1/2 the size in all dimentions. The top ones are ok, the bottom ones would be the pain.... Tough to get the eggs out. 2 or 3 rows of nests using 1/2 the space, not as low, woulda made for happier chickens - they want a small secure area when looking for a nest, off the ground a little.
Chickens like to have a roost to sleep on - 2x with a screen nailed to the bottom edges so the poop falls through and no chickens can get below. They do a lot of pooping at this time, nice to have a spot they can't get to where it all falls. You want that someplace else than where the nests are.
In front of the nests, a couple inches away, you want a 1x3 (or 2 1x2 is better, and flat, so the 3-4 inches is the top surface) or so as a landing pad for the chickens to land on, & hop into the nest. They will not like flying up & dropping into the edge of the nest (tho your large nests should work out for this) they will prefer the flatter ledge in front a few inches.
Worst part of your 2x ledge nailed directly to the front is they will want to use this for the roost, and will tend to poop in the nests......
To use the top nests, they need enough airspace to hop/fly up there. Think it will work, but you have a small building, not so much space in there for them to get a run & fly at it. On the 3-tier nests we had, the bottom landing roost was a foot out, the top landing roost was only 2-3 inches out, giving them a bit of a ladder effect as you mention.
They like to land on a flat surface, like to roost on a 2x surface. You can control where they do what with that info....
But, lovely work, don't want to be critical. Wow, just for chickens!!!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
