Posted by trucker40 on February 06, 2008 at 11:58:02 from (69.154.214.97):
In Reply to: Stuck tractors posted by Ryan Mueller2 on February 04, 2008 at 21:14:31:
Hardly anybody has time or patience to unstick a motor.If you want to work on it,you want to work on it now.Maybe you can get lucky and find one that you can get un stuck before your patience runs out,maybe not.It takes a couple of weeks usually at least,and thats if its not stuck real bad.I think one that might work on a motor thats stuck bad is,clean as much rust as you can off of the cylinder walls that you can.Get it clean as you can on the bottom of the cylinder walls.Find or make a pipe that fits just inside the cylinder then I would weld a plate in it to make it solid.Then rig a way to put a hydraulic jack on it and I would soak it with penetrating oil,atf,lucas,marvel,whatever,maybe even burn some of it right on top,not getting it real hot,on all the cylinders.Then after all that put a little pressure on it.If it wont move then,take the crank out,push one at a time.They still might break if its stuck real bad.You would want that to be a real close fit to the piston and make it where it couldnt get down between the piston and block,if that happened it would be a big problem,thats why I would weld a plate inside to keep that from happening.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
