Posted by dave2 on February 13, 2008 at 01:06:47 from (139.139.35.70):
In Reply to: pole barns posted by John S-B on February 12, 2008 at 15:48:06:
The places that I have for horse pastures are not allowed to be built on (permanent structures with foundations). You can build a pole type building with a removable floor (not poured concrete or asphalt) up to an area of 75 cubic meters though, so there is a bunch of pole structures around. I was told the way to do it is dig the hole about 18 inches deeper and about that much wider than you need it, put in and pack the bottom with 18" of up to 1 inch slag gravel 9not smooth rocks), set the post and fill/pack it with up to 1/2 inch of the same stuff. some say not to use tar because it holds moisture in???. I'm trying this in the next couple of months and will paint what will be about 6 inches above and below ground level with tar and cover it with tin. Supposed to be the ticket. I'll tell you in a hundred years or so.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
