Posted by Mark - IN. on February 23, 2008 at 07:29:50 from (205.188.117.74):
In Reply to: Gasket fire rings? posted by 37 chif on February 22, 2008 at 20:43:24:
O-ringing the deck surfaces between the block and heads give a better clamping affect because the grooves cut to hold the O-ring in place in higher compression applications, such as turbo charging. There was a guy whose name I won't mention during the late '70's whom I suggested that to going into the Indy time trials, before the Indy time trials. He was one of the first to run a "stock block" as they referred to his small block chevy, even saying it was out of a school bus, which it really wasn't. There were some conditions that sent up a red flag to O-ring the cylinders. When it came time for the time trials he did ok for the first couple of laps...and a head gasket let go, and he/they didn't qualify. In the garage area afterwards I walked over and asked, "Did you O-ring the cylinders", which I suspected they had not. He/they were pretty mad and we'll let that just go at that, other than to say they had not. It was a fairly new or little known or thought of technology at the time and still, O-ringing the cylinders is a good idea when dealing with higher compressions at least. Who knows, these days with technologies being what they are, they may just use some space age stuff out of an spray can that does they same for much cheaper. I doubt it, but give kids a computer loaded with cad and they'll design a space shuttle out of plastic and paper, and it'll probably blast off and fly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
