I have not personally welded a rear. I have run solid rears. You turn by spinning the inside tire. So you've got to romp it, every time you turn.
If you're talking a track car, that's just fine. A solid rear works just fine. If you're talking a street car, it'll drive you nuts, and little johny-law will be following you around town writing you tickets at every turn.
Two alternatives to think about. Spools and lockers. Both are fairly cheap.
A spool is a locked rear. It works just like welding the rear, just no welding is involved. They also don't break, which welded rears are notorious for doing. They are cheap and pretty easy to install.
A locker, aka a lunchbox locker, is a drop in modification. They cost anywhere from $150-400 depending on new or used, and who's name you buy. I ran a lock-rite for some time. Others swear by ausy. Detroit is nifty but real expensive. They are quite streetable, though they definately have a personality. Turns are frequently noisy and lurchy, but much more doable than with a locked rear.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.