Tractor Talk Discussion Board |
Re: John Deere 510 batteries
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by ltf in nc on January 01, 2000 at 16:06:36 from (206.228.213.74):
In Reply to: John Deere 510 batteries posted by Ron corkum on January 01, 2000 at 15:05:06:
I have converted all of my dual battery equipment to a single battery except for my Cat loader. If I could get the amps from a single battery for this task I would convert it also. My reason for converting is that two battery posts are less problem prone than four. Also, in most instances I was running two 12 volt batteries in parallel and in that arrangement the voltages regulator senses the condition of the best battery therefore one battery is always less than peak charged. One high amp battery is usually cheaper than two batteries. However, in your case since you have to contend with weather that is probably colder than I experience you need to do some research prior to converting. Verify the amp requirement for the tractor and then determine if you can get a single battery that can deliver the CCA (cold cranking amps) equivelant to, preferrable exceding, the two 6 volt batteries. Also realize that all batteries are not the same. The labels lie. Very few, if any, of the batteries will deliver the stated capacity written on them. Buddy up with some heavy equipment operators and ask them what brand they are using and try to get a concensus of opinion. Do not ever think about going to any Auto Discount type store, not even for the family cruiser. The best battery that I can locate here in N C is a Deka. The local dealer only stocks the low and medium ampacity and I have to get him to order the high amp batteries. He states that the public will not pay the higher price for the best battery. It is only another $10 or so. Poor quality batteries are the main source of starter failure on most equipment. If you use large enough cable the length on a tractor should not be a problem. Can't help with the battery box as I am not acquainted with you model of tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Antique Tractor Wiring Basics - by Curtis von Fange. One of the most neglected parts of old tractors is the wiring. After sitting in the elements for half a century or more much equipment wiring has deteriorated to sparsely covered strands of copper or other metal. Plastic insulation has cracked, mice have eaten through the older clothed style coverings and the exposed wires have reacted to winter moisture and salts by turning blue and powdery. Terminal ends have corroded, rusted or just plain evaporated away. Aged wires not only keep an engin
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|