Posted by hydraulic lines on March 05, 2008 at 21:16:16 from (68.149.51.25):
In Reply to: Re: Steel Hyd. lines posted by Bruce Hopf on March 05, 2008 at 20:24:44:
JIC are flare fittings that are used on hydraulics. They don't need to be reefed super tight and don't need any tape or sealant. O-Ring fittings are also used. JIC and O-ring fittings have straight thread. NPT pipe thread is tapered. Galvanizing can flake off and ruin hydraulic components. There is no comparison to gas lines for your house and hydraulic lines. Hydraulic tubing is smaller to take up less space and is about the highest quality tubing you can buy. Hydraulic tubing is also sized to prevent turbulance from different size fittings which will cause excess heat which you don't want. Water pipe isn't seamless. For a low pressure system like on a tractor (2500 psi), water pipe can work. Hydraulic tubing can be bent to go around corners and fit exactly. Water pipe needs a bunch of fittings and can't come close to being tucked in as nice. More fittings equals more potential for leaks and heat. I've never seen large expensive machines use regular pipe for hydraulic lines. I would think the manufactures would want to use the best lines they could.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
