Posted by Dan-IA on March 09, 2008 at 13:31:37 from (216.51.179.77):
In Reply to: Busting up concrete posted by Andy T on March 08, 2008 at 16:47:38:
Neighbor had the same problem. What you need is a bigger tractor, say a 4020 or a 756 or 1855 or bigger, and a westendorf loader with forks on it. This is a two-man operation in that you can"t see what you"re doing worth a d*mn from the tractor seat, but the guy out front can direct you. If you can get the tips of the forks to dig into the ground enough to just get under the slabs of concrete, when you lift the loader the cement will break up in chunks. Then you can remove it without any problems. The hard part is getting the forks to start digging into the soil just a little ways ahead of the concrete so they can get down far enough to get under the slab. This is easy if it"s just a cement slab, it"s tougher if you have concrete footings 18 inches deep.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
