Posted by Roy in georgia on March 12, 2008 at 17:40:20 from (71.28.180.151):
talked to Mr. Chastain today he told me that what is happening is when you drill you blow air in as you drill and the sand stone will have shelves that the veins feed in water as he drills the shelves get the particles in them and as the water finally comes through the blockage it washes in the fines and thus causing the sand. He also told me he never hit granite and set the pump at 150 ft. because there was no need to set it further he hit water around 80 and with the 20 gpm it was filling faster than I could pump it out. I asked him how he measured gpm he said the easiest way was to have a 5 gal bucket and stopwatch to see how long it takes to fill it up. and with the new veins I think it may even be better. I looked at the filter when I got home and no visible change in the amount of buildup after washing clothes and baths yesterday evening. Randy told me to call him next time he may have to come pull the pump and put something on the end to help filter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.