Posted by Bob M on March 13, 2008 at 10:12:04 from (151.190.254.108):
In Reply to: 12 valves? posted by Dan-IA on March 13, 2008 at 07:21:36:
No wierd gimmick. As pointed out below some current production Ford engines use a 3 valve head.
It's not exactly a new idea either. Back in the 70's the Honda CVCC engines used a 3 valve/cylinder setup. As I recall it had 2 different-sized intake valves. The larger ome admitted a relatively lean main mixture; the other admitted a small volume of a richer mixture. I presume this was done to reduce emissions.
And going back to the late the 1930's the IHC "gas start" diesels also employed a 3 valve arrangement. However on these engines a smaller 3rd valve was used only during starting to open up spark plug chamber and to lower the compression ratio.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
