rgvtx, You didn't say where in Texas this was?. here in Williamson Co. We are from $5000/acre to $30000+/acre. Yes that is 30,000/acre. A 300 acre ranch sold a while back for that. It will be sub-divided for houses. I know of a 100 acre place just N. of the new down town of Cedar Park Tx. He has turned down 50,000/acre! I didn't studder here. Cedar Park,Tx. is just N. of Austin., and is considered part of the Austin Metro area. Also Williamson is the fastest growing county in the Nation! Go to San Saba, LLano you will be into $2500 on up to $5000, Land ave in the rural area will ave around that. The Metos will be higher as long as others still move to Texas in droves, to enjoy our good economy, (Sun-time) the North doesn't have. Today was almost 80 degrees, tommorrow almost 90! the rest of the North land is still covered in Snow! One could have been in shorts and t-shirst the last couple of days. Hope this helps. Later, John A. OBTW I will let go of 88 acres @ $23,000/ acre If you are instreted. I am just N. of Cedar Park about 18 miles, along US 183. A prime little ranch for some Horseey people! Later, All!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
