Posted by VADAVE on March 20, 2008 at 16:27:05 from (72.196.249.67):
In Reply to: shop size posted by ;RIVIR on March 20, 2008 at 13:42:28:
Mine's 30X40X17. I put a 12 foot balcony along one 30 foot wall sized for light industrial, that's to store parts. Underneath is a kitchen, for parties, a bath with shower, clean up befoe going to the house. I store no equipment in the shop, it's for working on the stuff. The shop is built on the end of a 100X40X17 machinery storage building. I put a 10X10 door in the 40 foot wall seperating the shop from the machine storage area THAT was the mistake. In order to bring equipment in I sometimes have to clear two 16 foot storage bays. Were I to do it again that 10X10 door would be on an outside wall! The personnel door is on the other (outside) 40 foot wall. And it isn't too small yet. OH Yeah Overhead propane heat and insulated as thick as possible.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
