I know the feeling well. Being newely married I'm in the middle of remodeling/repairing my house before we move into it. We've talked about it numerous times but I still don't think she really understands why we can't put a huge, one piece tub and surround combination (she doesn't like the seams in the others) in the existing bathroom without taking a wall out. She has one in her house which, to me, was obviously set in place and built around. Thing is her bathroom is smaller than the one in my (her new) house so it just doesn't make sense to her why the bigger bathroom can't have the same tub in it. Just can't seem to make her understand even the old one would be a pain to get out through the existing door and the new one she want's simply won't fit without taking out a wall. Looks like I'm going to be building and tiling a custom tub shower combination before too long, not to mention tiling the kitchen cabinets and back splash as well as an area in front of the fireplace...on top of repairing wood rot around both the front and back doors and replacing both doors, putting down a new floor, taking paneling down and refinishing the sheetrock behind it, redoing the ceilings, etc etc etc.... Everything we're doing really needs to be done since the house was never really refinished after a downstairs flood from a burst pipe upstairs nearly 13 years ago but she's sticking with me through the whole construction ordeal. I love her and she want's a nice house as much as I do so I'm doing all I can to make it happen for her. Of course it really helps when she understands I need the tools to do the jobs she want's done. She got me a nice 10" tile saw for my birthday and then also a new Bosch 7 1/4" skill saw I wanted to replace the old junker I picked up out of the scrap yard years ago, not to mention a new wet/dry vac to clean up the resulting construction messes. I've used all my new tools already and am loving them, and her, more every day.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
