Build the French Drain. And put the inner edge under the siding. When the wind is blowing towards that barn face there can be as much rain from the siding as from the roof.
I did that for mine on the door side and driving over the drain has not seemed to have wrecked it. I dug maybe a foot deep, but sloping and tapered it a good three feet wide. I lined it with sturdy plastic (I used roofing bitumen underlayment, the stuff you use to prevent ice dams from leaking through the roof edge), I put in a 4" perforated drain tile, and I filled with 3/4" clean limestone. Sand and fines tend to plug it up. That 3/4" clean (expensive!) doesn't pack or plug.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
