Will, I won't pull & pull & pull on a small engine... What works for me on small engines which have sat for a long time is: 1) Turn the main mixture screw at the bottom of the carburator bowl OUT about 1/4 turn (if it has one). 2) Remove spark plug and put about a teaspoon of gas in the cylinder. Replace plug. Set controls for normal cold starting.
Most will start right up on the first or 2nd pull.
Reset mixture screw after it warms up for smooth running (about half way between smokey-loping and lean-sputtering) at medium throttle.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.