I guess that's a tough one. See what the insurance guy has to say, I guess. I've thought of replacing mine with a rounded concrete pillar like mark that property corners, but they set off of the road about 10'. Using (forming) one for a mailbox would be up at the road, and I've had the same concerns in Indiana that if I do that and someone hits it hard, would I become liable? But, I'm pretty rural, and my road was dirt until recently when a politically connected guy down the road got the county to chip and seal it. Now what few vehicals do come down the road go faster than they used to on dirt, but pretty much slow though, like 20 or 25. If they're behind me, its about 10. My bigger concern is if the snow plow guy hits it and tilts it over, then I'll have to dig down 4' or so to straighten out a 1.5' diameter concrete column. Would it be worth it? I don't know. And no one has ever damaged the angle iron one I have, so...?
Something to concider, is that even those big light posts on streets and the interstates are designed to sheer off for a reason. Your neighbor means well, don't anger him. Don't get into trouble. Whatever your insurance guy says, I guess.
I wish that guy down my road didn't get us chip and sealed (quasi-paved). Heck, with the oil poured and built up and packed down in front of the houses on my road over the years, it served as black top to cut down on dust by the houses, and almost no one that didn't live down our dirt road didn't wander down it. Now we have some wanderers. Not many, but some. Dang that guy. If he wanted asphalt he should've moved into or nearer town. I cut him slack though. He's generally a nice guy and still works his AC-WD and an Oliver 60. I still wish he hadn't done that though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.