Tractor Talk Discussion Board |
Re: Tandem Tractors
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by RLC on January 15, 2000 at 22:56:20 from (199.120.105.97):
In Reply to: Tandem Tractors posted by Wardner on January 14, 2000 at 16:56:41:
In the late fifties and early sixties we did alot of plowing with a JD 70 and JD 60 in tandem. A side frame from an F20 Farmall was used as a reach from the drawbar of the 60 to the drawbar of the 70. A very large (3"?) ball on the 60 drawbar and the 70 drawbar slid ahead just to expose the hole in the end for a bolt. The 70 pedestal was removed and a welded up mount supported the front of the tractor on the reach. The 60(front tractor) hydraulics were used for a 5 bottom pull-type plow. Throttle and clutch were operated by pushrods that went from the front of the 70 to the appropriate control. The tractors operated quite well one gear apart, and were quite easy to syncronize. You did need to throttle the rear tractor down a bit in a sharp turn situation. Both tractors and the hitch setup still exist on the farm, but have not been used in tandem since probably around 1965.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|