Posted by KEB1 on April 15, 2008 at 10:18:33 from (192.91.171.42):
In Reply to: 6 volt or 12 volt? posted by javan on April 14, 2008 at 18:41:19:
They were all six volt positive ground originally. If it actually has an alternator and not a generator, it's most likely been converted to 12 volt negative ground. There are six volt alternators available, but I'm not sure why someone would go to the effort of replacing the generator with an alternator & not convert to 12 volts.
There are a couple places to look for indications. First, the most telling indication is the charging system itself. Where is the voltage regulator mounted & how many wires come out of it. If there's one wire to the batter & one wire to the generator, its a cutout relay & almost certainly still six volt. If there are three terminals, its not a cutout relay and could be either 6 or 12 volt. If the regulator is mounted on top of the generator, it could be either six or 12 volt. If the regulator is mounted separately from the generator or alternator, its most likely (but not absolutely) either an alternator (12 volt negative ground) or a 12 volt generator.
Second, if a 12 volt conversion was done properly, there should be either a ballast resistor in series with the hot side of the ignition coil, or the coil itself should have been replaced with a 12 volt one. If there's no ballast and the original coil, its probably still 6 volt. If its magneto ignition, this wouldn't apply as a magneto operates indpendently of any electrical source.
Check more light bulbs. If they're all six volt, its a good bet the tractor is still six volt, unless of cours as previously pointed out they're all burned out.
One last option is to take the generator/alternator/regulator to someplace that specializes in generators & alternators & have them identify it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
