Posted by Dsl on April 27, 2008 at 10:40:22 from (216.209.133.183):
In Reply to: SNOW REMOVAL posted by Skybow on April 27, 2008 at 09:31:11:
Loader buckets only make you chase 'windrows' of snow over and over if you are trying for a clean job. They also make the sides of the lane higher, causing it to catch more snow. Diverting the snow off of the lane into (many) piles only makes for deep drifts as the piles divert the wind and cause it to dump it's snow load on either side of the pile. An angle blade is an improvement over a bucket, but still creates a catch basin for snow.
The BEST way is to blow it away; there is then much less to nothing to catch drifting snow and hold it, reducing the number of times you have to repeat the process. Go for the snowblower. You will find it a colder job with the snow vaporizing around you in eddies, but if you dress warm with a water repellant outer shell, and wear a full face helment (or have a cab), you won't be sorry. Take it from a Canuck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
