Posted by buickanddeere on May 03, 2008 at 08:59:00 from (209.240.118.34):
In Reply to: Re: JD 70 pony motor posted by James22 on May 03, 2008 at 06:49:13:
You do have to go 24V starter. A 12V unit is a tough go to make work anytime, in particular in any weather where a jacket or coat is required. A plate steel bracket will allow a 42MT to be used which is a step up from the 40MT. The cast bracket doesn't have the room. It's going to take a pair of group 31 batteries and 4/00 cable too.
Sad to say most of these dreams of a cheap, easy swap to electric. Turn out to be expensive half finished projects that get pull started.
We use airplane gas in the starting engines and it doesn't varnish, gum or get stinking. In fact any of todays pump gasoline keeps better than the stuff sold even into the 1990's.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
