Read very carfuly what Ia Gary said. I spent many hrs on them and be sure to keep the ground clear of anything to trip on. They are safe, fast, but must be respected. Make sure the wood is firm on the table, or perhaps I should say tight to the surface that the saw will force it towards. If you get to many RPMs the saw will warp as it spins, as will a dull blade.
Those saws were noted for making men show off as to how fast they could cut. The saws will always win in the battle of stupid.
Always stand off just a little to one side of the blade. Also the flat belt can slap you if you jamb the blade.
Any idea as to how old the steel in the spinning blade is? Compare the speed it cuts a log the same size of your arm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.