As previously stated the hazards in man and machine all existed around my Maternal Grandfather's buzz saw.
It was front mounted on a well abused JD low seat standard chassis AR then later a l.s.s.c 60 .
Any guards were long gone as "they only got in the way, we don't need them and they slow down work.
The table frame still existed but the plank on top was partly broken/missing. "No time to repair it and the saw still works". The log of course would hang up when pushed across the table for the next cut.Then suddenly move as you pushed towards that screaming blade.
He would also saw as hard and as fast as possible letting the cut blocks pile up around the saw until it just wasn't possible to cut another block. Then reach in there right beside the blade and start yanking on blocks of wood to clear the blade.
It was usually raining or snowing on wood sawing days so they were walking and crawling on wet,muddy,icey wood and wood bark.
My Mother as a kid seen her GrandFather almost get sawed in half. He stumbled (no surprise and no shields). And fell face 1st towards the blade. He managed to get his hands out and stop himself without getting them cut off either. Great GrandFather was left with a wound from the tip of his nose, between his eyes and up his forehead.
I heard some body say the classic line one time and it's true." Some people were put on earth to be an example, others were put here as a warning".
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
