Posted by Pycoed on May 13, 2008 at 13:55:45 from (86.166.253.10):
In Reply to: o/t what is silage posted by dangerdoc on May 12, 2008 at 10:18:37:
Over here most silage is made by cutting, re-cutting , crimping & blowing lush green grass into rows. This is done with forage harvester. The grass is then left for a day in our temperate climate to wilt then baled into large round bales & wrapped tightly with black balewrapping plastic. The balewrapping machine is towed behind the baler. Each bale then ferments within its wrapper & you can see them inflate with the CO2 produced as if they've been inflated. This is why vertical silos are dangerous: its the CO2 - the silent killer. Some are just piled in field corners but most are stacked in the yard/shed. Rats & crows are a nuisance if they peck through the wrap 'cos the sileage will rot wherever there is air present.
Another way is to trail a special high capacity trailer with high sides made of 1/2" mesh towed by another tractor alongside the forager (or sometimes towed by the forage harvester ) This grass is blown by the forager straight into the trailer then carted into large three sided concrete pits & thoroughly compacted by running another tractor up & down the clamp. When full the silage pit is covered with plastic, sealed round the edges with earth & usually covered with old tyres to weight it down. Effluent from silos is VERY POWERFUL pollutant & there are lots of regulations for drainage, sumps & disposal of the fluid. BIG fines for any pollution incidents.
Lots of maize (which doesn't fully ripen in our climate) & other special forage crops grown just to make sileage, but grass silage has taken over from hay across the country in the last 20-30 years
Haylage is much used in "horseyculture" & made in small bales or even mini round bales wrapped like the big uns.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.