Posted by Sam#3 on May 29, 2008 at 04:02:00 from (70.129.184.189):
In Reply to: DR equipment posted by Bill46 on May 28, 2008 at 10:09:29:
I have one of the small engine driven and my brother has a 3pt. We both have them for the same thing, brush clearing and trimming. They are not big production machines but for the jobs that reoccur every few weeks I feel they're the ticket. The one thing you need to know is the material needs some trimming. The feed chute (on mine) is three and a half inches square. If a sapling is two inches and the branches will fold nice and close to the trunk it will go through in one feed. However, if the branches spread and are tough you need to trim. Get a good set of bypass loppers and avoid dead material. I've run mine nearly four years and still haven't sharpened the cutter.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.