Posted by francisp on June 02, 2008 at 19:44:25 from (75.49.119.35):
hi in texas first i had split this tractor to rebuild the motor,it went back together kinda tite,,i wasn't too sure about it so i resplit it,then i found out it was only the clutch,so i reassembled it then started it up,ran great and still does ,now when i try to shift,the gear lever hangs up hard in 1,2,4,and 6,,but you can hear it grinding and moving a tiny bit forward but i dont need to be doing that,now it will go into reverse and back up but theres still a chattering sound,,,,the lower gear range on the shifter area 3,5,7,and 8,,it drops right into place but i'm not sure that it grabs nothing because even the clutch is not needed,,aside from all this trouble,i can't get my hydraulic pressure back,may be due to the lack of me not knowing what to bleed first but man i hope that i didn't tear up anything stabbing it the first time,,if so ,is there any way to remove the floor and gain access to take a look into this problem,if not,,whats the easiest way to pull the cab?thanks guys any help is appreciated
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
