Posted by 135 Fan on June 06, 2008 at 18:53:24 from (24.70.95.205):
In Reply to: Any Ideas? posted by Allan In NE on June 06, 2008 at 05:38:17:
A harder pin would help with wear. Easy job for an Arc-air torch (gouger). Is it welded on both sides? I'm thinking it's only welded on the outside? If you're good with a cutting torch and don't push the cutting lever all the way you could probably cut most of the old weld out. You could also go buy or rent a die grinder with a ball end carbide burr and grind the weld out. I've seen cheap air die grinders for under $20. They work fine for occasional jobs and are very handy. Electric ones are also available but cost more. Get a good carbide burr though. Make sure to wear a face mask and/or googles when using a die grinder. They throw the shavings everywhere. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
