|
Tractor Talk Discussion Board |
Re: Best Screws for Barn Tin ???
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Bryan on February 01, 2000 at 22:09:41 from (207.90.236.38):
In Reply to: Best Screws for Barn Tin ??? posted by Diesel Dan on January 30, 2000 at 19:30:38:
I just built a 36' x 48' pole barn with painted sheet metal siding and used three types of screws. These may be trade names but any hardware store will know what they are, TEK SCREWS for sheet metal to metal supports; WOOD GRIP SCREWS for sheet metal to wood posts; LAP TEK SCREWS for sheet metal to sheet metal (overlaping peices and trim). They all have hex heads and can be found in different colors to match the metal siding. I STRONGLY suggest pre-drilling the holes when joining sheet metal. I also suggest using a sealing tape between the overlaps of the roof (if it's metal) to keep rain out. Good luck
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
