I rid my area of five of these critters last year: Two shot, and three trapped. Haven't seen any around yet this year. Yet.
If you haven't had any luck shooting them (or if you have close neighbors or some other reason that gunfire just isn't safe), the best way I've found is trapping them.
Go to the link below and look at the Bridger body traps. I think you'll want either the 6" (#160) or 7" (#220) traps. If groundhogs are that much of a problem on your spread, you'll want to buy *at least* a half-dozen traps.
First, attach the trap to something reasonably heavy so that it won't get dragged off; I use an old bush-hog flail and some worn-out tire chains. Now, set the trap -- but watch your fingers!
Next, place a trap over every burrow you can find. Some of them are woodchuck residences, and others are just places they dig so that they have somewhere to go hide if they sense danger.
Finally, camouflage the trap with a few handfuls of fresh-pulled blades of grass, but leave the opening visible.
With any luck, the traps will spring when the intended target either pokes its head out of its burrow to go and maraud your vegetable garden, or rushes back into it when fleeing danger. (O, the irony!) The traps usually catch them across the waist and chest, and the end comes rather quickly.
I then take the carcasses some distance away (onto a powerline that runs parallel to the property line) and leave them belly-up. The crows or coyotes/other scavengers do the rest.
I like using the traps, as they avoid the use of poisonous methods and are much more discreet than gunfire.
Good like with your campaign, and let us know how you make out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
