Posted by john in la on June 22, 2008 at 10:21:43 from (67.35.255.126):
In Reply to: Soundguy re: Ford 621 posted by coflyboy1 on June 21, 2008 at 19:49:15:
I tried to explain your axle type in your last post but maybe you did not see it so here goes...
Ford made 3 axles in the time frame your tractor was built. 1) A regular adjustable axle for the ag tractors. Your 641 most likely has this axle. 2) A heavy duty adjustable axle for the ag tractors. This axle looks the same as the regular ag axle but the wheel bearing; center pivot pin; wheel hubs; spindles; ect are different. (They are heavy duty) Your 621 has this axle if the sticker is original and not just something someone stuck on there for looks. 3) A solid non adjustable industrial axle. Your tractor can not have this axle because there is no such thing as a 601 light industrial. It would have been called a 2000 not a 601.
Some other differences between your 641 and 621 are......... The 641 came stock with gauges; hyd system; 3 point; PTO; swinging drawbar; lights; and tool box with tools. None of these are standard on a 621 but all were offered as add on options. The best way to explain it is by looking at say a Ford pickup. The 621 is the XL model and the 641 is the XLT model. You can get everything a XLT pickup has on a XL pickup it is just not standard equipment on the XL. Cost extra to add it. A lot of state or city tractor were 621's because they could buy it cheaper and add PTO but no 3 point. They did this because they pulled drag brush cutters rather than 3 point cutters.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
