As other have already stated, without some prior tillage that field cultivator would be nothing but a big dump rake. For several thousands of $'s you could buy a much newer field cultivator which can get thru without any previous tillage. Chopping stalks with a rotary mower or flail stalk chopper is not going to save the day. A rolling stalk chopper which isn't cheap either might work. I suggest a single or if necessary, a double pass with a disk in the fall (not in the spring) which should allow you to successfully use that cultivator. However be aware that 3pt cultivators are only considered scrap metal by serious farmers in this area. Depth control is a concern with a 3pt implement. A soil finisher which is basically a field cultivator with a set of front disks, will work good, but also probably a little pricy. Strip till is fine, but plan on spending a lot of $'s to buy or build a machine. Probably a better plan would be to hire someone to make the strips.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.