Posted by buickanddeere on July 06, 2008 at 05:35:44 from (209.240.122.79):
In Reply to: Re: torque specs. posted by bill mart on July 05, 2008 at 17:58:07:
While some of your guys are being being so holy. Guess who actually does have the specs while the rest of you don"t? Assuming this is a gasser and not a LP or all-fuel. Here"s some data but it"s going to hurt him more than it helps him. 132 psi compression,slow idle rpms 600, fast idle 1260, full load rpms 1125. Tappet clearance 20 thou, points 22 thou. Initial timing TDC, mechanical advance 20 degrees. Coolant system 6-1/2 gallons, crankcase /filter 8 gallons, hydraulics 11 quarts, pto clutch 4 quarts, 1st reduction gear 1-1/2 quarts, power steering 5 quarts. Spark plugs 35 lb ft, cylinder head 150 lb ft, block to crankcase 167 lb ft, rod bolts 100-110 lb ft, main bearing caps 150 lb ft, flywheel bolts 275 lb ft, fan and oil pump drive nut 30 lb ft, oil filter body to oil filter head 14 lb ft, oil pump to main case 83 lb ft, vent pump screws 21 lb ft. Rear wheel to rim bolts 100lb ft, rear axle housing to main case 167 lb ft, final drive gear housing to drive shaft housing 275 lb ft, rear axle housing/cover pto/hydraulics 83 lb ft, drawbar support to rear axle housing 458 lb ft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
