Posted by ScottyHOMEy on July 09, 2008 at 07:14:37 from (64.222.247.98):
In Reply to: Farmall Super A Brakes posted by Wheat Farmer on July 09, 2008 at 05:52:53:
That's an odd part to be missin' there, Farmer.
If I'm readin' right what you DO have is the little toggle that pivots on a pin toward the rear of the slot in your floor pan. If so, what's missin' is a whole chunk of steel that welds to the outside of the right brake shaft. It's not something I think you'll find as a separate part. If you don't have a pedal guard, I suppose it could have been torn off, but that's a real long shot. Otherwise there really isn't enough stress in its regular function for it to fail on its own.
If it is missing, you ought to be able to find evidence of it having once been there. If you can get thee to a parts book, you might get a better idea of what and where it is, but I'll try to describe it. It was flat on the bottom, with a radius on top that was notched with teeth (similar to those on your speed control) that engaged the pawl on your toggle. It was the same thickness as the flat steel of the cam on the end of the brake shaft. It was welded, with the flat bottom offset to the rear, in line with the inside of the cam, that is before it was offset out to where the rod to the brake band connects, with enough clearance between to get a cotter pin into the back side of the clevis pin.
Maybe someone has a pedal layin' around in the parts heap that could measure one up to give you some actual measurements that you could use to fab one up. If not, it might be easier to find a salvage shaft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.