Posted by Gene Bender on July 19, 2008 at 04:01:30 from (67.55.226.165):
In Reply to: Super C overheats posted by Dan-IA on July 18, 2008 at 22:34:23:
You dont need a over-running device on a 6ft belley mower. First i would drain the coolant. Then using OLDS method of filling with vinegar. Letting the vinegar set for a couple of days. Your problem is probably in the block as the passages for the coolant are the size of a nickle and i will bet they are plugged or pretty much plugged. After draining the vinegar i would remove the radiator and lower housing. Using compressed air clean out the passage followed with flushing with water. Using stiff wire and a good flashlite you will be able to find the small holes and clean them you will find a good amount of crud in there. When you think you have the area cleared run water in the top filler neck into the head and then watch thru the lower openoing in the block you should see water coming thru the holes. I just tore down four blocks and everyone had those holes almost or were plugged with crud up to an inch or more deep. Everytime i replace new sleeves i find the same. This is also a good time to replace the fan and generator belt and check the fan shaft for oil inless it has been replaced with the newones with bearings. You can add a water pump at this time also then you will really be in good shape just be sure your pump comes with a pulley. I have been working with these tractors with mowers and without for the last 15yrs done a bunch of them the 6ft on a C makes a fine mowing outfit and it sounds like yours runs off the pto newer ones drive off the belt pulley and and are a better set-up. good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
