Posted by ScottyHOMEy on July 31, 2008 at 19:05:23 from (70.105.249.132):
In Reply to: This is fun.... posted by Lanse on July 31, 2008 at 18:19:15:
Since it's soundin' like you're gonna have to pull this head one way or the other . . .
Turn it upside down or on its side or end, whichever way gravity will make the pesky scrap fall when it comes loose and tap GENTLY around the top and sides and see if that will jolt it loose. Please, don't be whalin' on it.
With the head off, blow some air at low pressure in the hole where the file tip is. Duct tape over any hole you can find where the air is coming out (bubble soap is good for finding those holes) except for the one closest to the hole in question. Then drive some air at higher pressure through that hole to try to blow it back.
And if that fails as long as you've identified the holes it connects to, I'm gonna suggest the wire again. Stranded and insulated, fairly heavy gauge. I don't know the diameter of the holes you'll be dealing with, but if you can get 12 or even 10 gauge in there, try it. As far as getting it around corners, use a pair of needle-nose to bend the very tip of the wire to somehere between 45 and 90 degrees. Start it in from the bottom with that bent tip facing toward the first corner, and by twisting it while pushing, the wire, the bent end will get itself around the corner and work its way up through.
I can feel for ya. We've all chased around some oddball thing like this, but it ain't worth scrappin' a head over. Just be patient with any of the various methods that have been suggested. Any one of them could do the trick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.