Posted by wallacedw on August 01, 2008 at 19:42:14 from (24.225.15.92):
In Reply to: Fuel path posted by Bob on August 01, 2008 at 19:16:08:
I'm not sure how you pull start a motor. It is a 236 ci motor. It cranks ok. I hook it up 2 my truck so even though it is a 6 volt system it is still turning fast and getting the spark.
The thing that I don't understand is that it used to start when fuel was poured into the fuel bowl (via the overflow tube). So maybe the squirt of straight fuel going into the air horn is wrong? Maybe it should be more of a fogging?
I am getting closer and I know when it fires and runs I am going to be thrilled/know I can go on... but it is very aggravating for it to work then not work. She was running but didnt have fuel from the bowl because the fuel line/pump/needle valve wasn't working. So I fixed that and now it doesn't want to play..... grrrrrr
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
