|
Tractor Talk Discussion Board |
Looking for Allis Chalmer part for MACk truck
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by Jon on February 21, 2000 at 18:43:56 from (202.43.252.144):
2-22-2000
Jono W Kusuma
To whom it may concern:
Dear Sir/mdm, I'm from an Engineering company in Indonesia which everybody here known as C.V Guntur Kusuma. From the surfing that I have been through for several days, I realize that the company of yours might be able to help me.
The main reason for me to write this letter is to ask your favor whether you have the parts that I have been looking for sometimes. I have a Mack truck and I'm looking for the CRANKSHAFT, MAINBEARING, CONNECTING ROD BEARING, ROD BEARING, LINER AND PISTON RING, which the engine is made by ALLIS CHALMER. Actually, I need the complete set of the bearing together with all the sides metals and I want them all new. The Cranshaft's type is 3500, the Crankshaft engine number is 3D-15948 and the engine catalogue number is 4028883. Also the Vin number is SJNR- 489RP-1189 and the engine number is SJNT-426-35003D-16028. On the other hand, the truck which is made by MACK, its serial number is 1189.
Eventually, as you have already known that I'm from Indonesia and will you do me a favor by replying me at jkusuma@hotmail.com or fax me at (011)(62)(31)(5452265) if you have all the parts that I need. As a conclusion, since I'm in Indonesia and I don't want to make any mistake, will you send me the pictures of the parts that I need with all the exact sizes through my e-mail and through the fax number above. Thank you for your time and consideration. I hope to hear from you soon. Your Sincerely,
( Jono W Kusuma )
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
